As I'm finishing up one small PSK (no doubt pictures and contents will follow soon) I had a revelation. Instead of putting the 2x3 signal mirror that I pirated from my Ritter PSP inside the PSK, why not put it on the outside of my PSK container (an Otterbox 1000), attached to a paracord lanyard where it could be readily gotten to without having to dump out the contents of the tightly packed PSK. Yet doing so would subject the mirror to additional punishment and abuse, potentially scratching the surface and decreasing its effectiveness. The small film that came with the mirror is hardly adequate for such a storage method. I was thinking that duct tape would work quite well, placed over the reflective side of the mirror and then peeled off when needed. But I do have some concerns, namely duct tapes ability to leave residue which would block the mirror. Has anyone tried this before? Does this sound like a good idea?