That's the slightly modified bits holder for me. I've tried to explain that with the first image above, but probably in too much details It's not ideal, as the plastic there quite soft, but often it's sufficient to do the job, especially if you pinch the center with your fingers. I plan to print it in white PLA to make it more rigid in the middle, more visible, and maybe with a couple more slots for bits.
WARNING & DISCLAIMER:
SELECT AND USE OUTDOORS AND SURVIVAL EQUIPMENT, SUPPLIES AND TECHNIQUES AT YOUR OWN RISK. Information posted
on this forum is not reviewed for accuracy and may not be reliable, use at your own risk. Please
review the full WARNING & DISCLAIMER about information on this
site.
It's not ideal, as the plastic there quite soft, but often it's sufficient to do the job, especially if you pinch the center with your fingers. I plan to print it in white PLA to make it more rigid in the middle, more visible, and maybe with a couple more slots for bits.
Previous Topic
Index
