Hi.

I can't see where the leak is coming from. As I screw the stove into the tank, just before the stove washer meets with the stove, I get a spray of extremely cold gas coming out from the entire circumference in between the washer and the stove. I have to continue screwing in for another approx. 1 and a half turns before the rubber washer meets with the stove. Until they meet, I get quite a blast of cold gas on my arm. If the coldness were my only concern, I could just put on a long sleeve, but I am concerned with the amount of gas I lose also.

Is this a tolerance problem mentioned above?

Thank you very much for your input.