Looks like a pretty good kit. I think the 35MM film canister is a bit bulky (for pocket carry) and those contents could be put in a much smaller container (or much more could be added to the film can). Using the can as a float is a neat idea, and you could also use a small stick as a float. I would be sure to add some tied flies to the kit and/or some other small lures. This would get you started fishing even if you had trouble finding any natural bait. I also like to put a knot diagram in my fishing kits since properly knotting monofilament is so critical.<br><br>When making an expedient fishing pole, the simplest approach is to just tie the end of the string to the tip of the pole. A far better result can be obtained if you can devise a loop at the tip of the pole for the string to pass through. You can then tie the line off to the base of the pole. This gives the pole far more "action" and helps eliminate shock loads on your string that can break it. It also gives you better control for casting and landing your dinner. A series of loops along the pole would be even better, but the loop at the tip is the most important one. The loop can be improvised from a safety pin, paper clip or wire, etc, or you can buy a real one form a tackle shop and I would include something for that purpose in the kit. Also a metallic red Glassmaster bass boat with 180 HP Evinrude outboard motor and sonar, if it'll fit.