as a comment to "need more gas...", I was recently given an old Honda generator, and after rebuilding the carb, needed to replace the fuel tank...instead of a tank, decided on a siphon/gravity feed from a 6gal fuel can... only trick was that the fuel line inlet was approx 1/4inch and could not find a double barbed connector/reducer for larger hose that would reduce to 1/4inch...had to make one...found a 1/4 barb x 1/4 pipe male, and 5/16 barb x 1/4 pipe female in brass at the local Ace hardware, and with a little teflon tape made an adapter....added a squeeze bulb to prime (be careful not to blow out the float needle/seat with too much pressure) attached to 7 feet of fuel line, and now have a multi task siphon/fuel line if needed (if I were to do it again would choose 3/8 fuel line as it would be quicker in a siphon mode as there were bulbs available in both 5/16 and 3/8)... just thought I would pass this idea along