Quoting the MFG specs-"Nylon 6.6 Properties:
Structure: Crystalline, Specific Density: 1.14, Water Absorption Rate: 1.3% @ 24 hr., Elongation: 150%, Tensile Strength: 7600 psi, Compression Strength: 8700 psi, Flexural Strength: 5800 psi, Flexural Modulus: 200000 psi, Impact: 2.1 ft. lbs./in. (IZOD), Hardness: R100, Deflection Temperature: 390°F @ 66 psi - 250°F @ 264 psi, Utilization Temperature: -110°F min / 250°F max., Melting Point: 490°F, Coefficient of Expansion: 0.000044, Arc Resistance: 130 sec, Dielectric Strength: 18 kV/mm
Bonding: Good, Ultrasonic Welding: Poor, Machining: Good, Transparency: Transparent, UV Resistance: Good, Chemical Resistance: Acids-Poor / Alkalis-Poor / Solvents-Good
Trade Names:
CapronŽ, DurethanŽ, GelonŽ, NylatronŽ, RilsanŽ, UltramidŽ, VydyneŽ, ZytelŽ
"
400F seems way too high. I worked in plastics for over 20 years and the glass reinforced nylon polymers we used in structural foam molding were molded in the 500F-600F range. I would not advise putting anythnig like a hot rock inside a synthetic sleeping bag. Boil some water, put it in a Nalgene bottle and wrap it in socks or towels. I can assure you a melted sleeping bag will sleep much colder than an intact one.
YMMV