I was only concerned about not starting off on the right foot. I have been following this forum for quite some time and have learned enough to know that I don't know nearly as much as some of you.
I feel the 95mm 4layer is the best sized knife. But again we run into the problem of if everything I wanted was on it, it would be like carring a brick in my pocket. Perhaps the 111mm also could be configured in such a way as to not make it too uncomfortable. Otherwise I would find myself "surviving" my equipment. <img src="images/graemlins/smile.gif" alt="" />
The I deal set up for me would be as follows:

Single Large Plain Edge Blade
Single Small Plain Edge Blade (clip point?)
Sissors
Large flat screw driver w/cap lifter and wire stripper.
(I would possible like to see the stripper sharpened like the one on the WAVE)
Can Opener w/small flat screw driver.
Wood Saw-- perhaps a double sided file--I don't know
Phillips Screwdriver <img src="images/graemlins/smile.gif" alt="" />
Reamer/Awl (do they even consider it an awl?)


I think this may be in production already. I don't know the models well enough. -- Maybe I could put the spark rod on a key chain I read about on another thread. Just a thought.

--Luke