Equipped To Survive Equipped To Survive® Presents
The Survival Forum
Where do you want to go on ETS?

Page 2 of 3 < 1 2 3 >
Topic Options
#194777 - 02/01/10 04:21 AM Re: Best Can or Metal Container to convert into a Pot? [Re: Susan]
SwampDonkey Offline
Veteran

Registered: 07/08/07
Posts: 1268
Loc: Northeastern Ontario, Canada
All good ideas people,

Hikemor/Nurit - I have never seen oatmeal in a tin container, I remember paper sacks, cardboard boxes and maybe a pressboard cylinder? I am not a big fan of oatmeal, but I guess I will be checking it out tomorrow.

Susan - Now beer I am fan of, but it was Heineken Can pots that I read the BPA report on, the ultra-light hiking crowd use these beer cans pots regularly and debate the health risk on the web. Draining them would be fun!

Hike4fun - I agree with you about the flat containers, I have lots of them but I think the tall "billy can" shape would be easier to use in this situation. My current pocket kit is in a flat steel tacklebox, but the items in this new kit would fit in a taller can better. I prefer square or rectangle containers to round ones as I find stuff packs in them better, but there are more round tin containers available.

Mike

Top
#194782 - 02/01/10 05:39 AM Re: Best Can or Metal Container to convert into a Pot? [Re: SwampDonkey]
Tarzan Offline
Member

Registered: 02/02/08
Posts: 146
Loc: Washington
If you have a Trader Joes anywhere near you, they have the Oatmeal in the tin can. Its about the same size as a one quart paint can with a friction lid. I have been thinking of putting some of these back for emergency food, Oatmeal does take a lot of water to prepare but it is nutritious and filling.

The Trangia container I use will hold an Esbit stove, tabs, emergency blanket, firesteel, and a disposable poncho, Not the most durable piece of kit, but a warm meal after a disaster or catastrophe could be a real morale boost. The wire handle has a plastic coating to insulate against heat and the lid stays on in normal use and carry

Top
#194785 - 02/01/10 05:44 AM Re: Best Can or Metal Container to convert into a Pot? [Re: Tarzan]
SwampDonkey Offline
Veteran

Registered: 07/08/07
Posts: 1268
Loc: Northeastern Ontario, Canada
Hi Tarzan, no Trader Joes here; but I did find an online Canadian supplier for the Trangia Containers tonight.

Later, Mike

Top
#194787 - 02/01/10 05:59 AM Re: Best Can or Metal Container to convert into a Pot? [Re: SwampDonkey]
dougwalkabout Offline
Crazy Canuck
Carpal Tunnel

Registered: 02/03/07
Posts: 3240
Loc: Alberta, Canada
Mike, I don't have suggestions that match your requirements exactly. I assume that you're on a tight budget?

My default tin for 'just in case' kits is the classic Tim Horton's coffee can. No coating AFAIK, one litre capacity, tight fitting plastic lid, and comes with decent camp coffee as a bonus. I recently got some Nabob tins on sale, also one litre size, that have a big sturdy lip inside the top of the can; I could drill a couple of holes in that lip for a bail and still have a sealed can to carry water using the plastic lid. Personally, I'd rather have two of these than one big can.

In my kits, I put a label on the coffee cans that says 'OK to cook in, ' -- just in case somebody else happens to be using it. They taste a trifle metallic when first boiled, so I prefer to discard the first batch of hot water (fine for washing though).

LOL at Sue's suggestion! I've kept a couple of those big Heineken cans for exactly that purpose. If I was going to use them regularly, I'd scrub out the inside with some fine sandpaper or steel wool and then boil the bleep out of them. The coating isn't thick. I'd use the same routine with 'found' cans in a survival scenario, using river sand as abrasive.


Top
#194788 - 02/01/10 07:15 AM Re: Best Can or Metal Container to convert into a Pot? [Re: Susan]
Hike4Fun Offline
Journeyman

Registered: 06/01/06
Posts: 80
Susan,

Who knows what they coat the inside of beer mini kegs with.
And aluminum containers are cheap to buy.

I admire the re-use and MacGyver creativity; however,
with all the chemicals involved and you are cooking at
high temps, why take a chance.

Lots of workers got sick from working near coal dust,
rock dust, asbestos, cooking oil, lead, mercury, flour, etc.
I think heavy metals are dangerous, and I even avoid tin or
aluminum. All these iron cans are coated with something.

SwampDonkey,
If you are making an Emergency only kit, any of the cans
that might be un-healthy would be OK, if you burn em out.

If this is a regular-use container, I recommend granite
ware with no "warm colors" on the old stuff. Granite ware
teapots, billy pots, bowls, and large cups are cheap and
available, e.g. Walmart camping and cookware sections.

Lighter weight, would be an aluminum pot with teflon,
which is (I think) safe and very easy to keep clean.

Top
#194789 - 02/01/10 07:50 AM Re: Best Can or Metal Container to convert into a Pot? [Re: Hike4Fun]
MostlyHarmless Offline
Old Hand

Registered: 06/03/09
Posts: 982
Loc: Norway
Now if someone please could produce a stainless steel hip flask without seams.... Or a similar rectangular stainless steel container, about 1" by 3-4" wide and about 5" tall. I guess that shape is kind of tough to produce from one lump of metal, no seams allowed.


I've been tinkering with a cut-down stainless steel hip flask for my kit. The flask is made of one cut-out bottom profile and a rectangular sheet that is wrapped to the "hip flask" shape, so it has one seam along the bottom and one along its length. The seams are probably welded or soldered. I don't know what kind of stuff the welding/soldering could release when you put that on top of a hot fire... Like plastic liners, it's probably not such a big deal for emergency, one-time-only use, but I still don't like the idea. It will have to do while I search for a better solution.

Top
#194797 - 02/01/10 01:22 PM Re: Best Can or Metal Container to convert into a Pot? [Re: SwampDonkey]
Am_Fear_Liath_Mor Offline
Carpal Tunnel

Registered: 08/03/07
Posts: 3078
Perhaps you could get some Swedish Trangia Mess kits in your area. In the UK they cost about $20 USD a piece.

http://www.youtube.com/watch?v=L-GHZ-l_tGw

They pretty tough and can be used either with the excellent Brass Military Trangia Burner (which has greater heat output and capacity over the excellent civvy one). It will boil 16oz 0.5 litres of water in around 8-9 minutes. Both pots are designed to also be used over a fire as described in the video. They are pretty neat well thought out compact kits.

Total weight with enough methylated fuel for about 4-5 days use is around 1.2 kg. There is also enough room to keep a drinking cup i.e. a double walled 300ml Snowpeak cup in their as well along with a folding ti-spook and a pot holder and lighter or matches.


Top
#194798 - 02/01/10 01:45 PM Re: Best Can or Metal Container to convert into a Pot? [Re: Tarzan]
hikermor Offline
Geezer in Chief
Geezer

Registered: 08/26/06
Posts: 7705
Loc: southern Cal
Originally Posted By: Tarzan
If you have a Trader Joes anywhere near you, they have the Oatmeal in the tin can. Its about the same size as a one quart paint can with a friction lid. I have been thinking of putting some of these back for emergency food, Oatmeal does take a lot of water to prepare but it is nutritious and filling.


I am sure that is why I purchased my container of oatmeal, which I opened the other day since it had been around a few years. I deemed it time to consume and replace.

To my surprise, when I pried off the lid and punctured the intact aluminum seal just below, the top layer of oatmeal had been compromised, probably by water, changing into some sort of gray muck, which also extended down the sides of the can an inch or two.

Had this been a real emergency, I would probably have tried to salvage some of the interior material, but, playing safe, I just pitched all the contents.

To my surprise, we were only six months past the "Best By" date of 06/2/2009 printed on the base of the can.

I think I will try again with a fresh can. I regularly consume oatmeal. It is nutritious, cheap, and sustaining. Add enough fruits and it is actually tasty.

One other thing. The directions on the can recommend cooking time of 30 minutes - not good in an emergency situation. I understand that in the old days in merrie Scotland, you grabbed a handful of oats,plunged your hand into a mountain brook, and breakfast was served. That's tough! perhaps some of our UK friends can comment further.
_________________________
Geezer in Chief

Top
#194800 - 02/01/10 01:50 PM Re: Best Can or Metal Container to convert into a Pot? [Re: SwampDonkey]
MostlyHarmless Offline
Old Hand

Registered: 06/03/09
Posts: 982
Loc: Norway
That Swedish mess kit is just so neat... a bit large, though, for this requirement:

Originally Posted By: SwampDonkey

One would be for a pocket kit, it would hold the kit Shelter components (AMK Bivy, Heatsheet, 50' nylon cordage, waterproof matches, firestarter). This container would be app. 2.5" in dia. and 4 to 6 inches tall, think 10oz soup can size.


These are the though requirements to meet.

A stainless steel water bottle would fit your measurements. Or a hip flask that you cut down (but those come with the wretched seams, not something you'd really like to use on a regular basis).

I am perpetually searching for a pot/container with the "cut down hip flask" form factor, but so far I've had little success. If I can't keep the thickness at or below 1.5-2 inches it won't fit a pocket anyway, so then I may as well toss in a small pot in a backpack.

Now I know there are lunch boxes of any shapes available, but using those for cocking is a really flimsy option. A flat tray about 1.5-2" high is hard to keep level over a fire or stove in the bush and the large surface gives a lot of evaporation.

Originally Posted By: SwampDonkey

The second container would be in a fanny pack usually attached to a snowmobile. This container would be larger, app. 6" in dia. and 6 to 8 inches tall, think juice can size.


This is the easy and fun part... the Swedish Army mess kit shown above is a very good alternative, but there are literally TONS of options for this size. Anything from coffee cans to Trangia stove+wind screen+mess kit combo will more or less fit within those volume/size restrictions.


Edited by MostlyHarmless (02/01/10 01:55 PM)

Top
#194805 - 02/01/10 02:39 PM Re: Best Can or Metal Container to convert into a Pot? [Re: MostlyHarmless]
SwampDonkey Offline
Veteran

Registered: 07/08/07
Posts: 1268
Loc: Northeastern Ontario, Canada
Excellent, now were "Cooking" with the ideas folks!

Doug - I checked the 2 coffee cans I had at the house and both had a plastic liner, but if Tim Horton's are clear then that is great, I can source them in my home town as we have 2 Tim Hortons here, EH.

Susan - you are correct in that this kit is probably just for emergency use and therefore not real a problem what container you use to heat water in. I have used a tin can billy many times and only recently discovered there was a plastic liner in them. I never cared until the Internet told me I should. Our local WalMart has some blue granite ware, can you expand on the "warm colours" concern?

Mostly Harmless - Yes a cutdown SS Water Bottle may work, I just have to find 10 cheap ones. My aluminum ones all have a liner.

Am-Fear_Laith_Mor - 10 Trangia Mess Tin/stove sets would solve the snowmobile kit problem, I will check the Canadian military surplus stores on the internet today.

Thanks everyone and keep your thoughts coming,

Mike


Top
Page 2 of 3 < 1 2 3 >



Moderator:  Alan_Romania, Blast, cliff, Hikin_Jim 
November
Su M Tu W Th F Sa
1 2
3 4 5 6 7 8 9
10 11 12 13 14 15 16
17 18 19 20 21 22 23
24 25 26 27 28 29 30
Who's Online
0 registered (), 717 Guests and 4 Spiders online.
Key: Admin, Global Mod, Mod
Newest Members
Aaron_Guinn, israfaceVity, Explorer9, GallenR, Jeebo
5370 Registered Users
Newest Posts
Leather Work Gloves
by KenK
11/24/24 06:43 PM
Satellite texting via iPhone, 911 via Pixel
by Ren
11/05/24 03:30 PM
Emergency Toilets for Obese People
by adam2
11/04/24 06:59 PM
For your Halloween enjoyment
by brandtb
10/31/24 01:29 PM
Chronic Wasting Disease, How are people dealing?
by clearwater
10/30/24 05:41 PM
Things I Have Learned About Generators
by roberttheiii
10/29/24 07:32 PM
Newest Images
Tiny knife / wrench
Handmade knives
2"x2" Glass Signal Mirror, Retroreflective Mesh
Trade School Tool Kit
My Pocket Kit
Glossary
Test

WARNING & DISCLAIMER: SELECT AND USE OUTDOORS AND SURVIVAL EQUIPMENT, SUPPLIES AND TECHNIQUES AT YOUR OWN RISK. Information posted on this forum is not reviewed for accuracy and may not be reliable, use at your own risk. Please review the full WARNING & DISCLAIMER about information on this site.