I obtained some of the high reflectivity red/white strips that are used for semi tractor/trailer marking. Was able to get three pieces to put in two regualr rectangular Altoid tins and one round Altoid tin. I debated long and hard with myself about putting them inside or outside. Finally settled on scotch taping them to the inside of the lid, with the reflective side towards the lid. Also punched a hole in each piece to allow it to be tied or clipped for use. Ran into a minor set back when both sides of the film were taped to the lid, it was hard to get them out, so I placed a thread under the film and when it is needed, the thread gets pulled which rips the tape. Been thinking of getting some good glow in the dark paint and painting some paper then laminating it and placing it in the kit as well. FWIW there is a great discussion thread on www.candlepowerforums.com that reviews some LOOONNG lasting and BRIGHT glow in the dark materials, be sure to choose search all dates though.

Best,
Comanche7